5 Great At Home Lats Exercises

Continuing in the series of articles, which I will provide you with a few exercises in each article, that will be specific for one main muscle group. However, most of these exercises will also work additional muscles as well. When this series of articles is complete, you will have an arsenal of exercises that will target every muscle group in your entire body.

Note: I do not recommend that you only target (or isolate) a single muscle group for a complete work out. When you attempt to "isolate" muscles by performing single-joint exercises, you are actually creating a body that is non-functional and will be more prone to injury. Essentially, you are creating a body that is a compilation of body parts, instead of a powerful, functional unit that works together.

Part Seven: Lats (Latissimus dorsi)  Exercises

Close-Grip Front Lat Pulldown

Main Muscle Worked: Lats
Other Muscles: Biceps, Middle Back, Shoulders
Equipment: Cable

1. Sit down on a pull-down machine with a wide bar attached to the top pulley. Make sure that you adjust the knee pad of the machine to fit your height. These pads will prevent your body from being raised by the resistance attached to the bar.
2. Grab the bar with the palms facing forward using the prescribed grip. Note on grips: For a wide grip, your hands need to be spaced out at a distance wider than your shoulder width. For a medium grip, your hands need to be spaced out at a distance equal to your shoulder width and for a close grip at a distance smaller than your shoulder width.
3. As you have both arms extended in front of you - while holding the bar at the chosen grip width - bring your torso back around 30 degrees or so while creating a curvature on your lower back and sticking your chest out. This is your starting position.
4. As you breathe out, bring the bar down until it touches your upper chest by drawing the shoulders and the upper arms down and back. Tip: Concentrate on squeezing the back muscles once you reach the full contracted position. The upper torso should remain stationary (only the arms should move). The forearms should do no other work except for holding the bar; therefore do not try to pull the bar down using the forearms.
5. After a second in the contracted position, while squeezing your shoulder blades together, slowly raise the bar back to the starting position when your arms are fully extended and the lats are fully stretched. Inhale during this portion of the movement.
6. Repeat this motion for the prescribed amount of repetitions.

Bent-Arm Barbell Pullover

Main Muscle Worked: Lats
Other Muscles: Chest, Shoulders, Triceps
Equipment: Barbell or Dumbbells

1. Lie on a flat bench with a barbell using a shoulder grip width.
2. Hold the bar straight over your chest with a bend in your arms. This will be your starting position.
3. While keeping your arms in the bent arm position, lower the weight slowly in an arc behind your head while breathing in until you feel a stretch on the chest.
4. At that point, bring the barbell back to the starting position using the arc through which the weight was lowered and exhale as you perform this movement.
5. Hold the weight on the initial position for a second and repeat the motion for the prescribed number of repetitions.

One-Arm Dumbbell Row

Main Muscle Worked: Lats
Other Muscles: Biceps, Middle Back, Shoulders
Equipment: Dumbbell

1. Choose a flat bench and place a dumbbell on each side of it.
2. Place the right leg on top of the end of the bench, bend your torso forward from the waist until your upper body is parallel to the floor, and place your right hand on the other end of the bench for support.
3. Use the left hand to pick up the dumbbell on the floor and hold the weight while keeping your lower back straight. The palm of the hand should be facing your torso. This will be your starting position.
4. Pull the resistance straight up to the side of your chest, keeping your upper arm close to your side and keeping the torso stationary. Breathe out as you perform this step. Tip: Concentrate on squeezing the back muscles once you reach the full contracted position. Also, make sure that the force is performed with the back muscles and not the arms. Finally, the upper torso should remain stationary and only the arms should move. The forearms should do no other work except for holding the dumbbell; therefore do not try to pull the dumbbell up using the forearms.
5. Lower the resistance straight down to the starting position. Breathe in as you perform this step.
6. Repeat the movement for the specified amount of repetitions.
7. Switch sides and repeat again with the other arm.

Chin-Up

Main Muscle Worked: Lats
Other Muscles: Biceps, Forearms, Middle Back
Equipment: Body Only

1. Grab the pull-up bar with the palms facing your torso and a grip closer than the shoulder width.
2. As you have both arms extended in front of you holding the bar at the chosen grip width, keep your torso as straight as possible while creating a curvature on your lower back and sticking your chest out. This is your starting position. Tip: Keeping the torso as straight as possible maximizes biceps stimulation while minimizing back involvement.
3. As you breathe out, pull your torso up until your head is around the level of the pull-up bar. Concentrate on using the biceps muscles in order to perform the movement. Keep the elbows close to your body. Tip: The upper torso should remain stationary as it moves through space and only the arms should move. The forearms should do no other work other than hold the bar.
4. After a second of squeezing the biceps in the contracted position, slowly lower your torso back to the starting position; when your arms are fully extended. Breathe in as you perform this portion of the movement.
5. Repeat this motion for the prescribed amount of repetitions.

 

Pull-ups

Main Muscle Worked: Lats
Other Muscles: Biceps, Middle Back
Equipment: Body Only

1. Grab the pull-up bar with the palms facing forward using the prescribed grip. Note on grips: For a wide grip, your hands need to be spaced out at a distance wider than your shoulder width. For a medium grip, your hands need to be spaced out at a distance equal to your shoulder width and for a close grip at a distance smaller than your shoulder width.
2. As you have both arms extended in front of you holding the bar at the chosen grip width, bring your torso back around 30 degrees or so while creating a curvature on your lower back and sticking your chest out. This is your starting position.
3. Pull your torso up until the bar touches your upper chest by drawing the shoulders and the upper arms down and back. Exhale as you perform this portion of the movement. Tip: Concentrate on squeezing the back muscles once you reach the full contracted position. The upper torso should remain stationary as it moves through space and only the arms should move. The forearms should do no other work other than hold the bar.
4. After a second on the contracted position, start to inhale and slowly lower your torso back to the starting position when your arms are fully extended and the lats are fully stretched.
5. Repeat this motion for the prescribed amount of repetitions.

  

 

Take these exercises, along with those from the previous articles and the ones that will follow in the next few articles, and combine them to create your own total body work out routine. In addition, put in place a healthy diet, and you will be well on your way to being healthy and fit.

Always remember to warm up for at least 5 - 10 minutes before beginning a work out routine.



Want some ideas for your abs? Give the Truth About Abs program a try.

Take a look at The Gabriel Method weight loss program, this guy lost over 200 pounds!

Related Posts

5 Great At Home Traps & Neck Exercises

5 Great At Home Triceps Exercises

5 Great At Home Biceps Exercises

5 Great At Home Abdominal Exercises

5 Great At Home Shoulder Exercises

5 Great At home Chest Exercises



If you liked this article, Please feel free to share it with your friends.